Psion OMNII Bedienungsanleitung PDF herunterladen (Seite 37)

Chapter 2: Basic Operation

Wi-Fi Config: Configure Tab

Psion Teklogix Omnii XT10 Hand-Held Computer User Manual 21

There are two methods available when configuring a radio network—you can either scan for

an existing network or manually create a network. If you tap on the Scan button, a list of

networks detected by the radio is displayed. Highlighting one of the listed networks and

tapping on the Add New button creates a new profile that is completed based on the security

capabilities detected by the radio. You may need to add additional information, depending

on your network requirements.

If you tap on the Add New button rather than the Scan button, you can create a

network manually.

• Enter the SSID (Service Set Identifier) for your network.

2.8.2.1 Authentication Mode

Omnii supports several classes of authentication—Open, WEP, WPA/WPA2 (Personal PSK,

Enterprise, CCKM-WPA, CCKM-WPA2), and 802.1x with EAP. Tapping on the Auth. Mode

menu displays your authentication options.

Important: The steps below describe how to manually create a network. Keep in mind

that this is intended only as an example

and may vary from your own

network requirements. If, for example, you are using a different type of secu-

rity for your network, the fields you complete may not match those described

here.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 357 358

Keine Kommentare

Psion OMNII Bedienungsanleitung Seite 37